8.2 Working depth of the levelling unit
If the levelling unit leaves furrows behind the roller:
→ Working depth of the levelling unit is too deep
If the tines leave furrows behind the roller:
→ Working depth of the levelling unit is too shallow
8.2.1 Setting the working depth of the levelling unit mechanically
The working depth of the levelling unit can be
adapted to the working depth of the tines at the
cranks.
1. Remove the linch pin (1).
2. Adjust the working depth at the crank.
3. Secure the adjustment using the linch pin.
• Turn the crank to the right
→ Reduce working depth.
• Turn the crank to the left
→ Increase working depth
• Set the depth at all the adjustment units in the same way.
• A scale is provided for orientation on the adjustment units
(2).
8.2.2 Setting the working depth of the levelling unit hydraulically
The working depth of the levelling unit is adjust-
ed hydraulically in working position using the
beige tractor control unit.
On the implement, there is a scale (0 - 8) that
indicates the set depth.
The values on the scale do not specify the work-
ing depth set in cm.
62
Cenius 03 BAG0144.5 10.19
To Next Page
Loading...
