Maintenance | 6-11
Background gas for analyte 2
Alphavalueforwirfilter
Beta value for wir filter
Beta value for wir filter
Power correction Z value 2
Pressure compensation coefficient 1
Pressure compensation coefficient 2
Pressure compensation coefficient 3
Pressure compensation coefficient 4
MidpointoftheDACrangeforTEC
control
ConcentrationofReferencecall
MidpointoftheDACrangeforTEC
control
Pressure compensation coefficient 1
Pressure compensation coefficient 2
Pressure compensation coefficient 3
Pressure compensation coefficient 4
Analyte1Concentrationinotherunit
2nd Concentration Unit of Measure
for analyte 1
Data Valid. 0=Not Valid, 1=Valid
0=Line-lock mode, 1=Sample,
2=Calib
Pressure and temp compensation.
0=none, 1=pressure, 2=temperature,
Process seal pressure span
Process seal pressure offset
ProcesssealpressureIIR
Sample channel's threshold
Sample channel 2's threshold
0=single, 1=dual concentration from
one spectrum
HeaterActuatorType.0=Reverse,
1=Forward.
Heater Deviation Tolerance. Ignored if
0.Otherwisehighorlowlimitalarm
are set when value is out bounds of 1
deviation