Ametek 5100 HD - Electrical Safety; Grounding; Safety Notes; Sample Gas

vi | Model 5100 HD Analyzer
Safety Notes
WARNINGS, CAUTIONS, and NOTES contained in this manual emphasize critical
instructions as follows:
An operating procedure which, if not strictly observed, may result in personal
injury or environmental contamination.
An operating procedure which, if not strictly observed, may result in damage
to the equipment.
Important information that should not be overlooked.
Electrical Safety
Hazardous voltages are present in the analyzer housings when power is applied to the
system. Always shut down power source(s) before performing maintenance or trouble-
shooting. Only a qualied electrician should make electrical connections and ground
checks.
Any use of the equipment in a manner not specied by the manufacturer may impair the
safety protection originally provided by the equipment.
Grounding
Instrument grounding is mandatory. Performance specications and safety protection are
void if instrument is operated from an improperly grounded power source.
Verify ground continuity of all equipment before applying power.
Sample Gas
Potential hazards of the sample gas should be taken into consideration
before connecting the sample to the analyzer. Personal protective equipment
and proper ventilation should be used if sample gas is toxic, ammable, or
corrosive. Check the sample line and all connections for leaks before pow-
ering up. Consult plant safety personnel for appropriate exhaust venting
guidelines for specic sample gas type.
NOTE

NOTE
