Web Interface | 5-1
WEB INTERFACE
Ethernet Connection
Use an Ethernet cable to connect the 5100 HD to the network. The minimum
requirement for the Ethernet cable is a CAT 5e. The maximum distance between
the analyzer and the hub is 100 m.
To install the Ethernet cable follow the steps below:
1. Disconnect the power from the analyzer and remove the cover on the customer
connection box.
2. Route the Ethernet cable through the cable entry port (see below) and into the
box.
2. Plug the cable into the LAN RJ45 connector.
3. Route the cable to the network connection in the plant and connect it.
To connect to the 5100 HD Analyzer web interface, you need to know the IP
Address used by your network. The IP Address can be found by using the analyzer
display to navigate to TEST CONFIG, then Network, then IP Address.
To Next Page
Loading...
