Ametek 5100 HD - Page 79

User Interface | 4-29
Data Type Description MB Starting
Regs
MB Reg Size
oat Heater Proportional Band 492 2
oat Cell Sample Time 494 2
oat Heater Deriviative Time 496 2
oat Heater Duty Cycle 498 2
oat Heater Integral Time 500 2
oat Heater Proportional Band 502 2
oat Heater Set Point 504 2
oat Ref Sample Time 506 2
int16 Midpoint of the DAC range for TEC control 508 1
oat Pressure compensation coe󰀩cient 1 509 2
oat Pressure compensation coe󰀩cient 2 511 2
oat Pressure compensation coe󰀩cient 3 513 2
oat Pressure compensation coe󰀩cient 4 515 2
oat Analyte 1 Concentration in other unit 517 2
char[20] 2nd Concentration Unit of Measure for analyte
1
519 10
uint Data Valid. 0=Not Valid, 1=Valid 529 2
int16 0=Line-lock mode, 1=Sample, 2=Calib 531 1
int16 Pressure and temp compensation. 0=none,
1=pressure, 2=temperature, 3=both
532 1
oat Process seal pressure span 533 2
oat Process seal pressure o󰀨set 535 2
oat Process seal pressure IIR 537 2
oat Process seal max 539 2
oat Process seal min 541 2
oat Sample channel's threshold 543 2
oat Sample channel 2's threshold 545 2
oat 0=single, 1=dual concentration from one
spectrum
547 2
oat TEC Temperature Value 549 2
int16 Heater Actuator Type. 0=Reverse, 1=Forward. 551 1
oat Heater Deviation Tolerance. Ignored if 0.
Otherwise high or low limit alarm are set when
value is out bounds of 1 deviation
552 2
oat Heater Deriviative Time 554 2
oat Heater Duty Cycle 556 2
oat Heater Integral Time 558 2
oat Heater Proportional Band 560 2
oat Heater Set Point 562 2
oat TEC Sample Time 564 2
oat TEC hysterisi 566 2