Ametek Amrel PLA Series - CALIBRATION; CALIBRATION INSTRUCTIONS AND PROCEDURES

M470039-01 REV-F Page 103
PROTECTION commands
OVER Voltage value VOLT:PROT:OVER[?]
OVER Current value CURR:PROT:OVER:[?]
OVER Power value POW:PROT:OVER:[?]
UNDER Voltage value VOLT:PROT:UND[?]
UNDER Current value CURR:PROT:UND[?]
UNDER Power value POW:PROT:UND[?]
OVER-V Time Delay VOLT:PROT:OVER:DEL[?
OVER-C Time delay CURR:PROT:OVER:DEL[?]
OVER-P Time delay POW:PROT:OVER:DEL[?]
UNDER-V Time Delay VOLT:PROT:UND:DEL[?]
UNDER-C Time delay CURR:PROT:UND:DEL[?]
UNDER-P Time delay POW:PROT:UND:DEL[?]
LIMIT commands
LIMIT Voltage MAX VOLT:LIM:MAX[?]
LIMIT Current MAX CURR:LIM:MAX[?]
LIMIT Resistance MAX RES:LIM:MAX[?]
LIMIT Power MAX POW:LIM:MAX[?]
LIMIT Voltage MIN VOLT:LIM:MIN[?]
LIMIT Current MIN CURR:LIM:MIN[?]
LIMIT Resistance MIN RES:LIM:MIN[?]
LIMIT Power MIN POW:LIM:MIN[?]
MODE and RANGE commands
MODE Query MODe?
CURR MODE MODe CC
MODe:CURR
VOLT MODE MODe CV
MODe:VOLT
RES MODE MODe CR
MODe:RES
POW MODE MODe CP
MODe:POW
MODE RANGE MODe:RANGe <n> 0…3
MODe:RANGe? <MODE>
SYSTEM RANGE SYST:RANGe[?]
STEP commands
Utility STEP LOOP UTIL:STEP:LOOP[?] <VAL>
Utility STEP COUNT UTIL:STEP:COUNT[?] <VAL>
STEP MODE STEP:MODE[?] <STEP COUNT> <MODE> (Must be in same mode and range)
STEP VAL STEP:VAL[?] <STEP COUNT> <VAL>
STEP TIME STEP:TIME[?] <STEP COUNT> <VAL>
UTILITY commands
Utility MEASure SENSE UTIL:MEAS:SENSE
Utility End Of Identifier UTIL:EOI
Utility TRansient Mode UTIL:TR:MODE
Utility Current value UTIL:CURR[?] <VAL> C value
Utility Range Operation UTIL:RANG[?] <VAL>