Ametek Amrel PLA Series - Mode and Menu Navigation

M470039-01 REV-F Page 25
Mode and Menu Navigation
Mode and Menu Navigation
1) In meter mode, press CV, CC, CR, or CP Hot Keys to make a mode selection.
2) In meter mode, press RANGE from the Front Key Pad to enter into range selection mode.
3) Press RANGE again to make a range selection from Low, Middle, High or Auto.
4) The first row displays the currently selected mode and main value
5) The second row displays the currently selected range.
6) Press “ENTER” key to confirm range, and go back to meter mode.
7) Press “CLEAR” key to go back to meter mode.
8) Press encoder, same as CLEAR key.
9) Press and hold encoder, similar to ENTER key.
Function selection mode
1) In meter mode, press FREQ, DUTY, or SLEW Hot Keys to enter into an edit mode.
2) Press SLEW to make a selection between rise time and the fall time.
3) Press DUTY to configure the duty cycle.
4) Press FREQ to configure the frequency.
5) Rotate  the encoder to edit value by each decimal place.
6) Press “CLEAR” key to go back to meter mode.
7) Press encoder, same as CLEAR key.
8) Press and hold encoder to enter and accept a value.
Menu mode
1) Press LOCAL/MENU key, or press and hold encoder to enter into menu mode.
2) Rotate  the encoder to select menu item.
3) Press “ENTER” or press and hold the encoder to accept the setting.
4) Press “CLEAR”, or press encoder to go back to meter mode.
Note: Please refer to the front panel menu tree section for detailed menu selections.
Panel Lock
1) When LCD is in “Menu Mode”, select “PANEL LOCK” can set PANEL ENABLE, and PANEL PASSSWORD.
2) When “PANEL ENABLE” is set to OFF, power off the PD unit and power on again, the local panel is disabled.
All other keys are locked except “LOCAL” key. When these keys are pressed, LCD displays “LOCAL
LOCKED”.
3) Press “LOCAL” key, users must enter PASSWORD. If the PASSWORD is correct, the LCD goes back to
normal state. Press “ENTER” key and “LOCAL” key in the same time locks all the keys again.
4) If users forget the password, they can use “555555” as default password.
List step edit mode
1) When LCD display is in meter mode, press STEP key from Front Key Pad to enter into step edit mode.
2) Press STEP key to make a selection between Time edit or Value edit of a step.
3) Press and hold the encoder to enter and accept the setting of a step.
4) Rotate  the encoder to select step point one by one.
5) Press “VALUE (9)” key to edit step value.
6) Press “CLEAR” key to go back to meter mode.