M470039-01 REV-F Page 61
MENU FUNCTION
The MENU function allows the user to set the different system configurations such as GPIB, Stepping, Max/Min setting,
Protection, and Calibration. The vast array of features and configurations allow the eLoad to accommodate different
situations or testing configurations. The Local/Menu function is the start of the tree structure, which enables the user to
branch.
Press MENU key:
* Use to select the next menu setting then press ENTER key to enter the selected menu.
* Use CLEAR key to back space or to correct the wrong value.
A: Load Control Menu - press ENTER key:
* Turn the encoder to select the next menu setting then press ENTER key to enter the selected menu.
* Use CLEAR key to back space or to correct the wrong value.
1. STEP PARAM.------- press ENTER key, use to select number of Step COUNT then press ENTER. (0 ➔
infinite)
2. MEASURE SENSE--press ENTER key, use to select LOCAL / REMOTE sense then press ENTER.
3. PORT0 ----------------press ENTER key, use to enables or disables digit port the press ENTER.
4. EXT. CONTROL-----press ENTER key, use to select ON / OFF then press ENTER.
5. SHORT CONTROL--press ENTER key, use to select ON / OFF then press ENTER.
6. CROSS MODE-------press ENTER key, use to select INPUT OFF / INPUT REMAIN then press ENTER.
7. CROSS RANGE----- press ENTER key, use to select INPUT OFF / INPUT REMAIN then press ENTER.
8. TRIGGER-------------press ENTER key, use to select Source (Held, BUS, EXTERNAL, ETHERNET) /
DELAY (in milli-second), then press ENTER.
9. PROTECTION--------press ENTER key,
1. OV PROTECTION--------------press ENTER key, input the STATE/LIMIT/DELAY then press ENTER.
2. UV PROTECTION--------------press ENTER key, input the STATE/LIMIT/DELAY then press ENTER.
3. OC PROTECTION--------------press ENTER key, input the STATE/LIMIT/DELAY then press ENTER.
4. UC PROTECTION--------------press ENTER key, input the STATE/LIMIT/DELAY then press ENTER.
5. OP PROTECTION--------------press ENTER key, input the STATE/LIMIT/DELAY then press ENTER.
6. UP PROTECTION--------------press ENTER key, input the STATE/LIMIT/DELAY then press ENTER.
7. V-ON CONTROL--------------press ENTER key, input the STATE/V-ON THRESHOLD then press ENTER.
10. MAX/MIN LIMIT---press ENTER key,
To Next Page
Loading...