Need help?Do you have a question about the Ametek Amrel PLA Series and is the answer not in the manual?
General| Brand | Ametek |
|---|---|
| Model | Amrel PLA Series |
| Category | Compact Loader |
| Language | English |
Displays symbols for safety warnings and device connections.
Overview of the PLA and PLW Series Programmable DC Electronic Load.
Explains model numbering for PLW and PLA series eLoads.
Describes the four primary operating modes: CC, CV, CR, and CP.
Details parameters for programming modes like Cross Mode and Ranges.
Explains how to set up and use transient operation modes.
Outlines the various protection features available on the eLoad.
Describes the LCD display, its indicators, and descriptions.
Explains the function of each key on the front panel keypad.
Details how to use the encoder for setting values and navigating menus.
Guides the user through navigating the eLoad's menus and modes.
Outlines the fundamental steps for setting up the electronic load.
Details on connecting AC power and selecting voltage.
Recommended water piping and coolant installation for PLW series.
Explains local and remote sense connections for accurate measurements.
Details on connecting multiple eLoads in parallel for increased power.
Instructions for trigger operation and zero-volt loading connections.
Overview of local operation capabilities, modes, and metering.
How to select operating modes and ranges via the menu.
Details on setting main level values for static operation.
Overview of SCPI commands for automated testing.
Lists SCPI commands for controlling the electronic load.
Cautions, environment, equipment, and local calibration procedures.
Using power interruption and input contactor features for testing.
Modifying step mode and selecting oscillation range settings.
Guides users on sweep operation and data capture using PC software.
How to configure and control units in a Master-Slave setup.
General specifications and parameters for the eLoad.
Power curves for PLA and PLW series models.
Compares PEL and PLA/PLW command syntax and parameters.
Specifies GPM and pressure requirements for water cooling.
Recommended installation procedures for PLW water piping.
Guides users on sweep operation and data capture using PC software.
Explains meter panel and graph displays (I-V, P-V).
To Next Page