Ametek Amrel PLA Series - PV SWEEP - PC Software Guide; Sweep Operation and Data Capture

M470039-01 REV-F Page 154
Install OUTLET TOP interconnect pipe to female threaded pipe at PLW rear panel.
Install OUTLET BOTTOM interconnect pipe to female threaded pipe at PLW rear panel.
Using one ranch fixed position on the female threaded pipe at PLW rear panel, and the other
ranch torque carefully at the interconnect pipe, Tighten the male end connection into the
mating female end connection until hand-tight approximately 2 threads. Then tighten the male
end connection until wrench-tight approximately 2 threads.
Locate the FLUID OUTLET distribution pipe. Install onto the interconnect pipes.
Using one ranch fixed position on the interconnect pipes, and the other ranch torque carefully
at the distribution pipe.
Installation Completed.