Ametek Amrel PLA Series - Calibration Configuration; Calibration Parameters

M470039-01 REV-F Page 105
CALIBRATION CONFIGURATION
There are two configurations for the calibration of the electronic load. One is for measuring voltage and the
other for measuring current.
FIGURE 5.1 – CALIBRATION SETUP CONFIGURATION
CALIBRATION PARAMETERS
The following are the parameters that are calibrated.
• CV main level programming.
• CC low range main level programming.
• CC high range main level programming.
• CR low range main level programming.
• CR middle range main level programming.
• CR high range main level programming.
• CP low range main level programming.
• CP high range main level programming.
• CV transient level programming.
• CC low range transient level programming.
• CC high range transient level programming.
• CR low range transient level programming.
• CR middle range transient level programming.
• CR high range transient level programming.
• CP low range transient level programming.
• CP high range transient level programming.
• CV readback.
• CC low range readback.
• CC high range readback.
0.01
PLW
+ -
+ −
+
−
POWER SUPPLY
−
+
DMM
(VOLTAGE)
DMM
(CURRENT)
CURRENT
SHUNT
INPUT