[Left/Right] to control the system is in
standby mode or in playing mode after the
record stopped.
When you select “Message” (reminding
message) option in “Timer Service”, the
screen will display like below:
vi. Wakeup Message: press [left/right] key to
select reminding message as Birthday,
Anniversary and General.
vii. Date, you can use numeric keys to input
your wakeup date.
viii. On Time: use numeric keys to input your
wakeup time. Once the time’s up, no matter
what the system is in standby mode or in
playing mode, the system will automatically
display a reminding message.
ix. The message will always display on the
screen, you can press [Exit] key to close it.
x. Standby After Finish:You can press
[Left/Right] to control the system is in
standby mode or in playing mode after the
record stopped.
xi. Extend Record Time :Press [left/right] button
or input the number using numeric keys to
set the Extend Record Time. It is used to
add time at beginning and end of the record
time.
xii. Press [MENU] key to exit the current menu.
11.5 A/V Control
When you enter “TV System” menu, you will see
the screen like below:
Display Mode is for switching the system output
video resolution. Highlight this option and press
left or right key, it will switch video resolution
circularly by the sequence “Auto<-> by native
TV<-> 480i<-> 480P<-> 576i<-> 576p<->
720P<->1080i-50<->1080i-60<->1080P-50<->108
0p-60”.
This effect is equal to press V.Format Key under
Full Screen and their last setting saving will be
efficient for each other. By Source means system
will set the video output resolution according to the
current program it’s playing, different resolution
programs switching perhaps will make TV screen
flicker. By Native TV means system will be
according to the HDMI TV’s max supported
resolution to set its resolution, if system is not
connected to a HMDI TV, it will set resolution to
default.
Aspect Mode is for switching the screen aspect
ratio mode. Now we provide following options: 4:3
PS / 4:3 LB / 16:9/Auto. You can press [Left/Right]
key to select each mode circularly. 16:9 will
provide user pillar box mode, it means user use
16:9 TV to display but need to see a 4:3 full display
picture. System will force press wide screen
picture to be narrow and there are black bands on
left and right side. Auto means system won’t do
any aspect ration translation, 16:9 picture source
will be good display on a 16:9 TV but will be too
narrow on a 4:3 TV, and 4:3 picture source will be
too wide in a 16:9 TV but will be good display in a
4:3 TV.
Video Output: Press [Left/Right] to select
HDMI or RGB.
Digital Audio Out is for setting both SPDIF and
HDMI’s digital audio output mode, it has options
LPCM Out, Auto, You can press [Left/Right] Key to
select each mode circularly. LPCM Out means
system will decode no matter AC3 or PCM audio
track data to be LPCM, digital audio decoder or
HDMI TV will get LPCM digital audio data. Auto
means system will detect which the connected
HDMI TV can decode and then output that data. If
HDMI TV can decode AC3, system just output
RAW data, if HDMI TV can decode LPCM only,
To Next Page
Loading...