12. System
When you enter “System” menu, you will see a
screen like below:
In “System” menu:
1 Press [Up/Down] key to select menu pages
among Information, Default Setting, Software
Upgrade, Upgrade By USB, Backup to USB
2 Press [OK] key to enter the selected item.
12.1 Information
1 When you enter “Information” menu, you will
see a screen like above. The screen
displays :MODEL ID,S/W VERSION,H/W
VERSION,LOADER VERSION,LATEST
UPDATE,STB SN,STB ID,CHIP ID.
2 Press [MENU] key to draw back to
““Information”” menu.
12.2 Default Setting
12.2.1 Default Value:
When you press [OK] key In the “Default
Setting” item:
1 There will display a dialogue box for you to
enter the password, the default password is
“0000”.
2 After you input the correct password, there
will show a warning message asking you
“The operation will load default and erase all
the channels that user added, continue?”.
3 If you select “YES”, all the revised
parameters of the receiver will reset to
default value. Please use this function
carefully.
4 In step 1 and step 2, press[Exit]key to draw
back from this item without saving.
12.2.2 Delete All Channels:
To Next Page
Loading...