CONNEX
TM
User Guide
35
4 Press and hold the Link button on the Ground Unit. The following message is then
displayed:
Pairing in progress
After a while, the monitor connected to the Ground Unit should display the video
received from the Air Unit, as described in the Ground Unit – On Screen Display (OSD)
section on page 30.
Note: If a black screen is displayed (as shown below), then check that the camera
on the aircraft is operating.
X To see a list of Ground Units with which an Air Unit is currently paired and
connected:
You may refer to the Checking the Ground Units Registered to an Air Unit section on
page 44.
X To clear all the Ground Units with which an Air Unit is paired:
You may refer to the Unregistering All Ground Units section on page 45.
To Next Page
Loading...