CONNEX
TM
User Guide
37
Chapter 4, CONNEX
TM
Management Application
This chapter describes how to configure and upgrade the CONNEX Air Unit and
Ground Unit.
Overview
The Air Unit and the Ground Unit come preconfigured to communicate with each
other. If needed, you can reconfigure the wireless video datalink by connecting the Air
Unit to a PC and using the CONNEX Management application, as described in the
Configuring the Link section on page 42.
The Air Unit and the Ground Unit come preinstalled with the latest firmware version. If
needed, you can upgrade the firmware of each, as described in the Upgrading the Air
Unit or Ground Unit Firmware section on page 40.
X To use the CONNEX Management application:
1 Install the CONNEX Management application, as described in the Installing the
CONNEX Management Application section on page 38.
2 Connect the Air Unit or Ground Unit to a computer, as described in the Connecting
the Air Unit or Ground Unit to a Computer section on page 39.
Note: Only a single CONNEX Air Unit or CONNEX Ground Unit can be connected to the
CONNEX Management application at a time.
To Next Page
Loading...