MANUAL FOR SYSTEM INTEGRATOR
20
NOTE: The default IP type setting of Video Door Phone is “DHCP Client “.
There is a reset button on the back of the DP3210
1. Pressing the reset button for 3 seconds=>DP3210 will turn into Statics IP mode as "192.168.0.50" and reboot by itself.
2. Or pressing for over 6 seconds =>Turn to DHCP mode as the default value and reboot by itself (Restore to factory setting).
Entering Web User Interface
Input the IP address of this product on your browser, then you will see home page of the Video Door Phone appearing.
Web UI is protected by Login ID and Password. Press the “Login” button, then you will see input fields: Login ID and Password.
Please key in the correct ID and password, and then press second “Login” button to enter Web UI. The default ID and password are:
Login ID: admin
Password: admin
NOTE：1. While configuring WEB UI (User Interface), please do not operate this product so as to prevent this product being out of
order.
2. Do not input special symbols “, \, and & in the fields on the WEB UI. Otherwise, you will fail to save your setting normally.
3. After configuring some Web pages and pressing “SAVE” button, you need to wait a little longer for system to save the
configuration.
To Next Page
Loading...
