Amtech Axpert-Eazy Series - Page 50

Amtech
6-4
6
No.
Parameter
Unit
Res.
Description
M624 Output Current6 Amp 0.1 Display the Output Current of Inverter Unit 6.
GROUP
-
7
M701 Control Version PI 0.01 Indicate ROM version of DSP Based interface board PCA-2013A/ PCA-
2049A for parallel inverter.
M702 Temperature IU-2
o
C 1 Actual heat sink temperature of Inverter Unit 2 is displayed.
M703 Temperature IU-3
o
C 1 Actual heat sink temperature of Inverter Unit 3 is displayed.
M704 Temperature IU-4
o
C 1 Actual heat sink temperature of Inverter Unit 4 is displayed.
M705 Temperature IU-5
o
C 1 Actual heat sink temperature of Inverter Unit 5 is displayed.
M706 Temperature DU-1
o
C 1 Actual heat sink temperature of Diode Unit 1 is displayed.
M707 Temperature DU-2
o
C 1 Actual heat sink temperature of Diode Unit 2 is displayed.
M708 Temperature Panel-1
o
C 1 Actual Inside temperature of Panel 1 is displayed.
M709 Temperature Panel-2
o
C 1 Actual Inside temperature of Panel 2 is displayed.
M710 Driver Status The ON / OFF state of driver fault status from Inverter Unit (IU) is be
displayed.
M711 Temperature IU-6
o
C 1 Actual heat sink temperature of Inverter Unit 6 is displayed.
M712 Short circuit status IU 1 ~
6
The status of short circuit or driver fault from Inverter Unit (IU) is
displayed.
M713 Over current status IU 1-
2-3
The status of over current fault from individual phase (current sensor)
from Inverter Unit (IU) 1, 2 or 3 is displayed.
M714 Over current status IU 4-
5-6
The status of over current fault from individual phase (current sensor)
from Inverter Unit (IU) 4, 5 or 6 is displayed.
M715 Over temperature Status
IU 1 ~ 6 DU 1 ~ 2
The status of over temperature fault from thermostat from Inverter Unit
(IU) 1 to 6 and Diode Unit (DU) 1, 2 is displayed.
GROUP
-
8 DEFAULT DIFFER
(CHANGE
PARAMETER
S
LIST)
This group provides the change parameters list, only the parameters which differ from default value and user also can
change parameters value from this group. Use UP or DOWN key for next changed parameters.