Initial Configuration
13
NXA-WAP250G 802.11b/g Wireless Access Point
Using the Setup Wizard
There are only a few basic steps you need to set up the NXA-WAP250G and provide a connection for
your AMX Control Panel and network access for other wireless devices.
The Setup Wizard takes you through configuration procedures for the general network settings, such as
IP configuration, wireless network name (Service Set Identifier), and wireless security. Follow these
steps:
To begin, login and select Start with Setup Wizard on the home page (FIG. 5).
Step 1: Operation Mode Setting
Select an operation mode according to how the unit will be used in your network (FIG. 6).
There are two operation modes:
AP: Set the device as an Access Point. The device can also act as a root bridge in a wireless
bridge network.
Repeater & Bridge: Set the device as a Wireless Repeater. The Root AP MAC Address can be
assigned manually or selected after clicking Scan.
Click Next to proceed.
FIG. 6 Setup Wizard - Operation Mode setting
To Next Page
Loading...