System Configuration
33
NXA-WAP250G 802.11b/g Wireless Access Point
The items on this page include:
Restore Factory Settings: Click the Restore button to reset the configuration settings for the
WAP-250G to the factory defaults and reboot the system. Note that all user configured
information will be lost. You will have to use the default IP address to re-gain management
access to the WAP-250G.
Reboot Access Point: Click the Reboot button to reboot the system.
Wireless VAP Settings
The Wireless VAP #1 Setting and Wireless VAP #2 Setting pages include configuration options for radio
signal characteristics and wireless security features on the WAP-250G (FIG. 30).
The following sections apply to both Wireless VAP #1 Setting and Wireless VAP #2 Setting pages.
If you have upgraded the system software, then you must reboot the WAP-250G to
implement the new code.
FIG. 30 Wireless VAP 1 Setting - main page
VAP #2 is only available when the Operation Mode is set as an AP.
It is recommended to restrict one VAP network for only AMX Control Panels and let
all other wireless stations use the other VAP network.
To Next Page
Loading...