System Configuration
44
NXA-WAP250G 802.11b/g Wireless Access Point
Filter
Use the MAC Filter option in the Filter page (FIG. 40) to enable the MAC Authentication filter. The
MAC Authentication filter can allow or deny any devices to gain access to the wireless network.
Click the MAC Filter link at the top of the page to access the following MAC Filter options:
System Default: Select Disable, Allow or Deny.
You must enable MAC filtering by selecting Allow or Deny, and clicking Save. Pressing Continue
enables you to add more MAC addresses. By default, MAC Filtering is disabled. If you select either
Allow or Deny, the MAC Address Table opens.
Allow: Select Allow, then enter one or more MAC addresses in the MAC Address Table to
only allow the specified MAC addresses to connect to the WAP. In this case, only the MAC
addresses listed in the MAC Address Table are allowed to connect to the WAP-250G.
Deny: Select Deny, then enter one or more MAC addresses in the MAC Address Table to
prevent the specified MAC addresses from connecting to the WAP. In this case, the MAC
addresses listed in the MAC Address Table are not allowed to connect to the WAP-250G.
FIG. 40 Filter page
To Next Page
Loading...