System Configuration
25
NXA-WAP250G 802.11b/g Wireless Access Point
Information
The Information pages display details on the current configuration and status of the WAP-250G,
including associated wireless stations and event log messages (FIG. 19).
Information - System
The System Information page (FIG. 20) displays basic system configuration settings, as well as the
settings for each wireless interface.
The items on this page include:
AP System Configuration: Displays basic system configuration settings:
System Up Time: Length of time since the WAP-250G was powered on.
MAC Address: The physical layer address for the WAP-250G’s Ethernet port.
IP Address: The IP address configured on the WAP-250G.
IP Default Gateway: The IP address of the gateway router between the WAP-250G and
management stations that exist on other network segments.
HTTP Server: The status of the web management server.
HTTP Server Port: The TCP port used by the web management server.
Version: The version number of the current WAP-250G software.
Wireless Data #1/#2 SSID Configuration: The AP Wireless Configuration table displays the wireless
interface settings listed below.
MAC Address: The physical layer address of the WAP-250G.
SSID: The service set identifier for this wireless group.
Channel: The radio channel through which the WAP-250G communicates with wireless
clients.
FIG. 19 Information page
The items on the Information pages are for status display only, and are not
configurable.
To Next Page
Loading...