System Configuration
24
NXA-WAP250G 802.11b/g Wireless Access Point
The Advanced Setup pages include the options in the table below. For details on configuration for each
feature, see the corresponding page number.
Configuration Options
Menu Description Page
Information
System Displays a summary of WAP-250G settings 25
Client Displays information on stations associated to the WAP-250G 26
Network Displays DHCP client, server, NAT, and PPPoE settings 27
Event Log Displays the system message log 28
System
Administration Configures the password for management
access
29
Operation Sets the device function 31
VAP Management Manages the VAP’s traffic and priority 32
Reboot System Restarts the system and resets configuration settings to factory
defaults
32
Wireless VAP 1, 2 (Wireless VAP 2 is only available when the Operation Mode is set to AP)
Basic Enables the VAP interface and sets the SSID 34
Channel Sets the radio channel 35
WEP Configures WEP security 36
WPA / WPA2 Configures Wi-Fi Protected Access Pre-shared Key (WPA / WPA2)
security.
38
Network
DHCP Client Enables DHCP client or manually sets an IP address 39
DHCP Server/NAT Enables DHCP server and configures NAT settings 41
PPPoE Configures PPPoE settings 42
Radius Server Configures Radius server settings for wireless clients. 43
Filter
MAC Filter The MAC Authentication filter can ALLOW or DENY any devices to
gain access to the wireless network.
44
Time
SNTP Sets the system clock using SNTP 45
Update
Upgrade via the Web Page Upgrades system software from a local file 47
Upgrade via a Remote Server Upgrades system software from a file on an FTP or TFTP server 48
To Next Page
Loading...