System Configuration
46
NXA-WAP250G 802.11b/g Wireless Access Point
Updating Firmware
You can upgrade new WAP-250G software from a local file on the management workstation, or from an
FTP or TFTP server. Use the options on the Firmware Upgrade page to update the access point system
software (FIG. 43).
After upgrading to new software, you must reboot the WAP-250G to implement the new code. Until a
reboot occurs, the WAP-250G will continue to run the software it was using before the upgrade started.
FIG. 42 Time Setting - SNTP Settings
FIG. 43 Firmware Upgrade - main page
To Next Page
Loading...