Appendix A: Troubleshooting
52
NXA-WAP250G 802.11b/g Wireless Access Point
2. Scroll to the bottom of the page and click Download Free TFTP Server located at the bottom of
the page (you will have to enter name, e-mail etc…).
Step 3: Choose Download Site and Install TFTP Server
1.
Select any one of the three links that appear on the screen to begin download.
2. Click Run - to install software on your computer
3. Click Run again to begin the software install.
4. Select all of the defaults during the installation
Step 4: Copy Firmware file
1.
E-mail a copy of the firmware file ZZ-IMG.BIN (Firmware file 1.0.4.6) to the dealer.
2. Copy the file into the C:\TFTP-ROOT directory
Step 5: Ethernet Connectivity
1.
Verify the Ethernet port is enabled and connect an Ethernet cable from the laptop to the WAP-250G.
2. Highlight My Network Places; Right-click Properties, Highlight TCP/IP Settings and click
Properties.
3. Assign a static IP Address on the same network as the WAP250
4. Click OK.
5. Click OK.
6. Click Start/Run and type CMD.
7. Ping IP Address of the WAP-250G to verify connectivity.
Step 6: Launch TFTP Server
1.
Start\Run\Program
2. Select Solarwinds Free Tools.
3. Select TFTP Server - the following window launches (FIG. 47):
4. The IP Address should reflect the same IP Address of your Ethernet port on your laptop and the
default directory (C:\TFTP-Root) is displayed on the bottom left.
FIG. 47 SolarWinds.NET TFTP Server dialog
To Next Page
Loading...