AMX NXA-WAP250G - Step 7: Change TFTP Server Settings; Step 8: Re-Connect to WAP 250 G

Appendix A: Troubleshooting
53
NXA-WAP250G 802.11b/g Wireless Access Point
Step 7: Change TFTP Server Settings
1.
Select File.
2. Select Configure.
3. Select the Security Tab and change selection to Transmit and Receive Files (FIG. 48).
4. Click OK.
Step 8: Re-Connect to WAP 250G
1.
Open a web browser and enter the IP Address for the WAP-250G.
2. Follow the Emergent Recovery System on-screen prompts to begin the Firmware upload.
FIG. 48 TFTP Server Configuration dialog