Initial Configuration
15
NXA-WAP250G 802.11b/g Wireless Access Point
PPPoE: The IP address is assigned automatically from an Internet service provider (ISP)
through an ADSL modem using Point-to-Point Protocol over Ethernet (PPPoE). If your ISP
has provided you with a user name and password, enter these in the corresponding text boxes
under PPPoE Setting (FIG. 9).
Static IP: The IP address is assigned manually by the user. This may be required if your
NXA-WAP250G is connected to a home gateway router or other device that does not support
a DHCP server (FIG. 10). Static IP is the recommended setting for your NXA-WAP250G’s IP
address.
FIG. 9 Setup Wizard - Network Setting (PPoE settings)
FIG. 10 Setup Wizard - Network Setting (Static IP settings)
To Next Page
Loading...