small amount of heat they produce under normal operating conditions; however, this
design is defeated when high heat-producing equipment is placed directly above or
below the enclosure(s).
Caution: We recommend 3 inches (7.6 cm) of clearance around the enclosure
openings. At a minimum, leave at least one empty rack unit above and below the
enclosure.
Mechanical (Rack) Loading
If installing equipment in a rack, distribute the weight to avoid uneven mechanical
loading.
Circuit Overloading
When connecting the equipment to the supply circuits, be aware of the effect that
overloading the circuits might have on over-current protection and supply wiring.
Reliable Earthing (Grounding)
Reliable earthing of equipment should be maintained. If not using a direct connection
to the branch circuit (e.g., plugging into a power strip), pay particular attention to
supply connections.
Caution: To avoid system damage, turn on all power switches for the AutoPatch
equipment at the same time before applying power to its source and destination
devices. We recommend attaching all power cords to a surge protector and/or an
AC line conditioner.
Installing the Precis
LT
5
To Next Page
Loading...
Need help?
General
