Anilam 3000M - Page 44

CNC Motion Setup/Testing Utility
P/N 70000635B - Index
Index-2 All rights reserved. Subject to change without notice.
November 2009
backup file, miscellaneous tests,
description, AC systems, 33
backup, restore from, amp
parameters, AC systems, 33
balance
adjustment (mV), setting, AC systems, 24
test screen, illustration, AC systems, 26
Balance (F6), 3
Balance (F6), AC systems, 22,
24, 26, 32
Balance (F6), DC systems, 11,
12, 13
Balance Screen, illustration, DC
systems, 18
balancing
DSP
2
board, AC systems, 22
DSP
2
board, DC systems, 11
motion control axes, 8
servo amplifier outputs, AC systems, 24
servo amplifier outputs, DC systems, 13
C
cable, servo amplifier
communications, P/N
33001389, 20, 22, 26
CanBus test
miscellaneous tests, description, AC
systems, 29
results display, table, AC systems, 29
screen, illustration, AC systems, 29
cancel
active MDI, 7
MDI, 3
test command, 3, 7
checking, axis resolution, 5
clearing
a message, 4
a prompt field, 4
ClrFld (F1), 3, 4
ClrFld (F1), DC systems, 19
CNC
Motion Setup/Testing screen, illustration,
2
Resolution Check (ResCheck) screen,
illustration, 5
troubleshooting tools, listed, 1
command, amplifier test link,
description, AC systems, 32
compensation adjustment (mV),
setting, AC systems, 24
configuration file
back up, 37
starting mark, entry, 6
D
DC systems
amplifier faults, 14
Balance Screen, illustration, 18
DSP
2
board
balance pots, illustration, 12, 13
balancing, 11
fault conditions
HS/ECB fault, description, 16
over temp fault, description, 17
over voltage fault, description, 17
under voltage fault, description, 16
jumpers, description, 11
LED fault conditions
1 LED, servo amplifier, table, 15
5 LEDs, servo amplifier, table, 15
LOOP GAIN pot, description, 13
servo amplifier
1 LED, illustration, 14
5 LEDs, illustration, 13
failure, 18
fault, resetting, 17
servo amplifiers, 10
servo drive, test board
description, 10
Signal Gain (SigGain), illustration, 19
signal gain, setting, 18
single-ended DSP
2
board, illustration, 9
test board, installation, 10
test points, listed, 11
derivative
gain (Kd), 30, 35
sampling time (Ds), 35
detecting, index pulse, 7
differential DSP
2
board,
illustration, AC systems, 9
DIGAMP-*.BK, AC systems, 23,
27, 33
digital amplifier
balance adjustment (mV), setting, AC
systems, 24
compensation adjustment (mV), setting,
AC systems, 24
enable, active, AC systems, 24
illustration, AC systems, 24
settings, to set, AC systems, 24
signal gain adjustment (%), setting, AC
systems, 24