17
2
3
8 mm
90︒
＞70 mm
4
5
12N·m
M8
Step 2: Mark pilot holes on the wall.
Fold the positioning card (included with the power module package) along the bottom crease.
Align the card with the top of the floor mounting base and use a level to ensure it is horizontal.
Select and mark a hole on each side based on the wall conditions to secure the first module.
If anchoring to a wall with studs, select position A for studs spaced 508 mm apart, position B for studs spaced 406
mm apart, or position C for studs spaced 304 mm apart.
Unfold the positioning card and align the bottom row of holes with the marked holes. Choose and mark a hole on each side
at the top for the second module.
Repeat the previous step to mark any remaining pilot holes as necessary.
To Next Page
Loading...
