11
P/N 1011550 Rev. D 03/21
Monthly Cleaning
The monthly preventative maintenance
steps include:
y Cleaning the Conveyor Belt Chains
y Checking the Conveyor Belt
Chains for Stretching
y Checking the Roller Tensioners
Cleaning the Conveyor Belt
Chains
1. Turn the unit o, unplug the power
cord, and allow the unit to cool down.
2. Put on heat resistant gloves.
Remove the Bun Feeder, Release
Sheet, and Bun Chute (Figure 11).
Set these item aside.
3. Set both Bun thickness Compression
Knobs to 6. Next, open both
Conveyor Covers (Figure 12).
4. Remove both Belt wraps (If
necessary) - lift the ap on the Belt
Wrap (Figure 13). Disconnect the
Belt Wrap hooks from the Conveyor
Chain and remove the Belt Wraps
from the toaster (Figure 13).
5. Inspect the Belt Wraps (if necessary)
for rips or tears. If the Belt Wraps are
in good condition, set them aside.
They will be reinstalled onto the
toaster later in this process.
6. Use a Hi-Temp Detail Brush
(Ecolab item# 92212765) to remove
all debris and residue from the
Conveyor Belt Chains. Do this on
both sides of the toaster.
7. Clean and sanitize the front and
rear Conveyor Belt Chain with a
green scrub pad sprayed with Super
Contact Cleaner solution. Wipe the
links of the Conveyor Belt Chain
rmly from side to side until they are
completely free of residue and debris
(Figure 14). Then, wipe the Chains
with a clean sanitizer soaked towel.
8. Plug in the power cord and turn the
unit on. Wait for both Conveyor Belt
Chains to rotate and expose the
uncleaned portion of the chains.
Turn the unit o. Unplug the power
cord. Repeat Steps 6 and 7 to clean
and sanitize the soiled side of the
Conveyor Chains.
NOTE: You may need to repeat steps 7
and 8 to ensure the Conveyor
Belt Chains are completely free
of debris and cleanser.
Figure 11. Remove Accessories
Bun
Feeder
Release
Sheet
Bun Chute
Figure 12. Open Covers
Figure 13. Remove Belt Wraps
Figure 14. Clean Chains
To Next Page
Loading...
