Antunes VCT-2 - Quarterly Cleaning

13
®
P/N 1011550 Rev. D 03/21
Quarterly Cleaning
The Quarterly Cleaning involves cleaning
the interior of the unit. Follow these
steps.
1. Turn the unit o󰀨, unplug the power
cor,d and allow the unit to cool down.
2. Put on heat resistant gloves.
Remove the Bun Feeder, Release
Sheet, and Bun Chute (Figure 11).
Set these item aside.
3. Set both Bun thickness Compression
Knobs to 6. Next, open both
Conveyor Covers.
4. Remove both Belt wraps if required.
Disconnect the Belt Wrap hooks
from the Conveyor Belt Chain and
remove the Belt Wraps from the
toaster (Figure 13).
5. Inspect the Belt Wraps for rips or
tears. If the Belt Wraps are in good
condition, set them aside. They will
be reinstalled onto the toaster later
in this process.
6. Disconnect the Conveyor Belt chains
by squeezing any two links together
and unhooking both ends of the one
link (Figure 19). Pliers may be used.
Remove the Conveyor Belt Chains
and set aside.
7. Use Hi-Temp Detail Brush (Ecolab
item# 92212765) to carefully remove
all debris and residue from the inside
components of the toaster (Figure
20). Do this on both sides of the
toaster.
NOTE: With proper and regular daily
and monthly cleaning, the
interior of toaster should be
free of residue and debris. If
youndthattheinterioris
extremely dirty on a regular
basis, please review how
the daily and monthly the
frequency and daily and
monthly cleaning steps.
8. Reassemble the Conveyor Belt
Chain onto the sprockets.
NOTE: Make sure the Conveyor Belt
Chain hooks are pointing
DOWN as shown in Figure 15.
9. Reinstall the Belt Wraps (if required)
onto the toaster under the yellow
rods and making sure the ap is
pointing down.
Figure 19. Disconnect Conveyor Belt chains
Figure 20. Remove all debris and residue with detail brush
Use a Hi-Temp Detail Brush
(Ecolab item# 92212765) to
carefully remove all debris
and residue from the inside
of the toaster.
Do this on both sides of the
toaster.
10. Connect the Belt Wrap hooks to the
Conveyor Belt Chain.
NOTE: Make sure the Belt Wraps are
installed under the support
rods.
11. Close the Conveyor Covers.
12. Reinstall the Release Sheet, Bun
Chute, and Bun Feeder and return
the toaster to operation.