Antunes VCT-2 - Reassembling the Toaster

12
®
P/N 1011550 Rev. D 03/21
Checking the Conveyor Belt
Chains for Stretching
1. Set the Bun Thickness Compression
Knobs to 6 and 6 and ensure both
Belt Wraps are removed.
2. Locate the approximate center-point
of the Conveyor Belt Chain.
3. Pull the Conveyor Belt Chain away
from the edge of the toaster (Figure
15).
4. Using a U.S. Dime coin (1.8 cm) for
reference or a ruler, measure the
space between the toaster frame
and the Conveyor Belt Chain (Figure
15). The coin should t snugly.
5. If the gap is more than twice the
width of the coin (2.6 cm):
y Disconnect the Conveyor Belt
chain by squeezing any two
links together and unhooking
both ends of the one link (Figure
16). Pliers may be used.
NOTE: There are two small 1/2 inch
links on each side of the
Conveyor Belt Chain. The rest
arelarge3/4inchlinks.
y Depending on how loose the chain
is, remove a 1/2” or 2/4” link.
NOTE: It is recommended to perform
the Quarterly Cleaning any
time you disconnect or remove
a Conveyor Belt Chain from
the toaster.
y Reassemble the Conveyor Belt
Chain onto the sprockets.
NOTE: Make sure the Conveyor Belt
Chain hooks are pointing
DOWN as shown in Figure 15.
y Measure the gap again to conrm
the gap is approximately the
width of the U.S. Dime coin.
6. If the Conveyor Belt Chain is too
tight, remove a small 1/2 inch link
and install a large 3/4 inch link in its
place. This increases the length of
the Conveyor Belt Chain by 1/4 inch
overall.
7. Repeat steps 1 through 6 on the
opposite Conveyor Belt Chain.
Checking the Roller Tensioners
1. Measure the Roller Tensioner on
both inner Conveyor Covers using a
U.S. Nickel (2.1 cm) for reference or
a ruler (Figure 17).
2. Adjust the Roller Tensioners as
needed by applying pressure to bend
the tensioner down or up so the coin
ts snugly between the roller and the
Conveyor Cover wall.
Reassembling the Toaster
1. Reinstall the Belt Wraps onto the
toaster under the support rods and
making sure the ap is pointing
down.
2. Connect the Belt Wrap hooks to the
Conveyor Belt Chain, ensuring all
hooks snap into place. (Figure 18)
NOTE: Make sure the Belt Wraps are
installed under the support
rods.
3. Close the Conveyor Covers.
4. Reinstall the Release Sheet, Bun
Chute, and Bun Feeder and return
the toaster to operation.
Figure 15. Measure with Dime coin
Figure 16. Disconnect Conveyor Belt
chain
Figure 17. Check Roller Tensioners
Figure 18. Reinstall Hook Belt Wraps