5
P/N 1011550 Rev. D 03/21
Installation
NOTE: When placing the toaster into
service, make sure to provide
at least 3 inches of space on
all sides of the unit.
1. Remove unit and all packing
materials from shipping carton.
The toaster is shipped with an
accessories box that includes the
items listed below:
y Bun Feeder Assembly
y Bun Chute
y Release Sheet (pkg. Of 2) A
Release sheet is also shipped
installed onto the unit platen.
y Owner’s Manual
NOTE: If any parts are missing
or damaged, contact
Antunes Customer Service
IMMEDIATELY at +1-877-392-
7856 (toll free).
2. Remove all packing materials and
protective coverings from the unit.
3. Refer to Figure 1. Wash, rinse,
and sanitize the Bun Feeder, Bun
Chute, and Cleaning tool at the 3
compartment sink and set aside to
air dry.
NOTE: The removable parts have
CONTACT etched on them to
make it easier to identify which
toaster they belong to.
4. Refer to Figure 1. Remove the
Release Sheet.
NOTE: Do not wash the Release Sheet
in the sink. The Release Sheet
must be washed by hand.
5. Wipe all surfaces of the unit with a
hot damp cloth.
6. Wipe both sides of the Release
Sheet with a hot damp cloth.
NOTE: Do NOT use a dripping wet
cloth. Wring out before use.
7. Install the Bun Feeder and Bun
Chute onto the unit (Figure 1).
8. Refer to the section titled Installing
the Release Sheet on the next
page. Install the Release Sheet
according to those instructions.
Figure 1. Components
Figure 2. Control Panel
9. When placing the unit into service,
pay attention to the following
guidelines.
y Make sure to provide at
least 3 inches of space on
all aides of the unit.
y Make sure the power switch is o
and the unit is at room temperature
before plugging in the power cord.
y Do not block or cover any
openings on the unit.
y Do not immerse the power
cord or plug in water.
y Keep the power cord away
from heated surfaces.
y Do not allow the power cord to
hang over edge of table or counter.
Bun Feeder
Release Sheet
Bun Chute
To Next Page
Loading...
