8
P/N 1011550 Rev. D 03/21
Adjusting Toast Quality
The unit can be adjusted to provide a
lighter or more darkly toasted product.
The lightest setting is 1 and the darkest
setting is 10.
Follow these steps to adjust toasting
quality.
1. To view the current Light/Dark
setting, briey press Light or Dark
button. The current Light/Dark
setting appears in the display.
2. To change the Light/Dark setting,
press and hold the Light or Dark
button until the unit beeps.
3. Press the Light or Dark button set
the Light/Dark value as desired.
Release the Button. The USE
message ashes in the display
as the unit adjusts the platen
temperature accordingly.
Hi-Limit Cap
Hi Limit Reset Button
A hi-limit control turns o power to the
unit if it overheats. To reset this Hi-Limit
control, allow sucient time (10-15
minutes) for the unit to cool down.
Remove the fan bae by pulling the
bae pin and lift the bae up and out
(Figure 5). Then remove the Hi-Limit
control cap by twisting the cap o by
hand or with a coin (Figure 6). Then,
press the reset button located on the rear
of the unit.
If the unit requires continuous resetting,
call for service.
Errors
The toaster displays any kind of error
message, contact Technical Service:
+1-630-784-3459
D4
USE
USE
Fan Bae
Bae
Pin
When the toaster reaches the newly
set Light/Dark temperature, the USE
message stops ashing and remains on.
The toaster is ready for use.
NOTE: The Light/Dark value is
maintained when the unit is
poweredo.
Shutting down the Toaster
To turn the toaster o, turn the Power
switch to the o position.
Reset to Default Settings
Follow these steps to reset the toaster to
the factory settings
Follow these steps to reset to default
settings:
4. Turn the toaster o.
5. Pres and hold both the Light and
Dark buttons and turn the toaster on.
6. Continue holding the Light and Dark
buttons until “fr” (factory reset)
appears in the display. The toaster
beeps when resetting is done and
starts up normally.
Figure 5. Remove Fan Bae
Figure 6. Hi-Limit Cap
To Next Page
Loading...
