9
P/N 1011550 Rev. D 03/21
Maintenance
WARNING
The unit will remain hot while it is
cooling down. Personal injury and
burns may result from touching the unit
before it is nished cooling down. Wear
Heat Resistant Gloves.
Daily Maintenance
NOTE: The following are general
maintenance procedures. For
additional details including
approved chemicals, please
see the Toaster Procedure
documents by scanning the
QR Code on the front page of
this manual.
The daily maintenance steps involve:
y Cleaning the Accessories
and Toaster
y Cleaning the Release Sheet
Cleaning the Accessories and
Toaster
1. Turn the toaster o and allow it to
cool before proceeding.
2. Refer to Figure 7. Remove the Bun
Feeder, Release Sheet, and Bun
Chute and set aside.
NOTE: Do not wash the Release Sheet
in the sink. It must be washed
by hand.
3. Wash the Bun Feeder and Bun
Chute in soap and water. Rinse with
clean water and allow to air dry.
4. Wipe all surfaces of the unit with a
hot damp cloth.
NOTE: Do not use a dripping wet
cloth. Wring out before use.
Cleaning the Release Sheet
1. Inspect the Release Sheet. Replace
the Release Sheet if it is worn,
creased, or torn.
2. Spray an approved cleanser on a
clean, dry towel.
3. Wipe the Release Sheet rmly from
top to bottom.
4. Repeat this procedure with a clean,
dry towel dampened with water.
5. Next, wipe the release sheet with
a clean towel dampened with an
approved sanitizer. Allow to air dry.
6. Repeat Steps 1 through 6 on the
inside portion of the Release Sheet.
Set the clean Release Sheet aside.
Cleaning the Belt Wraps
(9210922 ONLY)
1. Open the front and rear Conveyor
Covers (Figure 8)
2. Inspect the front and rear Belt
Wraps. Replace the Belt Wraps
if there are any signs of tearing,
folding, or other damage.
3. Turn on the unit.
NOTE: This step requires that the
toaster be turned on with the
Conveyor Covers open. Use
caution during these steps.
4. Spray a clean, sanitized towel with
an approved cleanser and wipe the
front and rear Belt Wraps for one full
rotation.
5. Repeat Step 4 with an approved
sanitizer.
NOTE: Repeat these steps as needed
until the Belt Wraps are clean
and tacky/sticky to the touch.
6. Reinstall the Release Sheet, Bun
Chute, and Bun Feeder and return
the toaster to operation.
Cleaning the Rear Fan
Use a clean dry cloth and wipe the
fan intake. The fan can be cleaned by
using an Ecolab Detail Brush (item #
92212765) followed by a clean, dry cloth
(see Figure 9). If there is heavy debris
buildup, follow directions for Quarterly
Cleaning the Rear Fan on page 14.
Figure 7. Remove Accessories
Figure 8. Open Covers
Figure 9. Rear Fan
To Next Page
Loading...
