User Manual
75
[Door sensor alarm delay (0-250)]:The Door sensor alarm delay time range setting.
[Default identification method on the device]: Set identification method for the device.
Such as: Fingerprint , Fingerprint+Password, Fingerprint+Password+Card
ID+Password, ID+ Fingerprint, ID+Password+Fingerprint, Card, Card+Password,
Card+Fingerprint etc.
[Time calibration(±60)]: Adjust the accuracy of time on device when you found the time
on device is abnormal. Time unit: Second.
[Registration Card mode]: There are 5 modes: Disable; Big endian,Wiegand 26 mode;
Little endian,Wiegand 26 mode; Big endian,Wiegand 34 mode; and Little endian,
Wiegand 34 mode.
For example: The original Mifare card number is ―21 00 A5 EA D9‖.
Big endian,Wiegand 26 mode
Little endian,Wiegand 26 mode
Big endian,Wiegand 34 mode
Little endian, Wiegand 34 mode
The factory default format is ―Big endian,Wiegand 26 mode‖.
[Management password(0-999999)]: Setting device management password.(Suit for:
C2, C2C, C3, OA1000 and OA3000 device)
[Sleep time (0~250 minute)]: How long does the terminal turn to the sleep mode if there
is no one operating on the terminal.
[Volume (0~5)]: The volume of the prompt sound in the terminal. The default value is 3.
[Date format]: There are three kinds date format: yy-mm-dd, mm/dd/yy, dd/mm/yy.
[Time format]: There are two kinds time format: 24 hour and 12 hour.
Click the button [OK] to confirm.
[Company name]: Uses for print to display the company name on the ticket.
[Company Address]: Uses for print to display the company Address on the ticket.
[Company Tax]: Uses for print to display the company tax number on the ticket.
Click the button [OK] to save the settings. Following message box pops up:
Click the button [OK] to confirm or click the button [Cancel] to cancel.
The operation information in the main interface is as follows:
[2011-08-25 15:05:08]Set Advanced Parameter...
[2011-08-25 15:05:10]1[Head office]Parameter setting successfully!
To Next Page
Loading...
Need help?
General
