www.anycubic.com
28
Printing Models
* Before printing, the nozzle only start to heat up after the heated bed
reaches the target temperature. After the nozzle and heated bed are
heated to the target temperature, the printer will start printing.
2. There might be three kinds of results for the first or second layer of the
test print:
① Nozzle is too close to the platform, resulting in insufficient extrusion of
filament.
② Proper distance between nozzle and platform can achieve the best
printing effect.
③ Nozzle is too high and the gap is large, which lead to poor adhesion of
filament to the platform.
To Next Page
Loading...
