www.anycubic.com
43
Introduction to slicing software
6. Print offline and online
There are two operational modes for Vyper: print offline and print online.
• Print offline: Insert memory card into the memory card slot, click on
the Home Menu “Print” to enter the file list, and print a selected file
(GCode files ONLY).
• Print online: Install CH340 driver to bridge PC and machine, and install
Cura for slicing and control the machine to print via data cable.
Vyper
Print offline
Insert memory
card
Print online
Install Cura, PC
control via data
cable
It is suggested to use Print Offline mode to minimize the noisy signal via
data cable.
l Print offline (Recommended)
After slicing, click Save to File in the bottom right corner. Save the
GCode file to the memory card, and then insert the memory card to the
printer and control via the touchscreen for offline printing.
* GCode file name should only contain English letters, underscore and
space. File name contains special characters could not be recognized by
the printer. In order to let the printer better recognize the GCode file in
the memory card, you need to back up all the files in the memory card to
the computer, and keep the memory card only for the GCode file. Please
save all the GCode files in root directory of the memory card.
To Next Page
Loading...
