www.anycubic.com
Please adjust the Z-offset patiently until the effect likes ②. If the printing
effect is still not good after multiple adjustments, please stop printing and
level the platform again.
30
Printing Models
3. The nozzle and heated bed are still at a high temperature when
printing is finished. Make sure to wait for nozzle and heated bed to cool
down before removing the model from the printing platform.
* Tip: To eject the memory card, please press it.
Note: When the ambient temperature is higher than 33°C, it is
recommended to change the slicing parameter "wall thickness" of the
model to 1.6mm.
To Next Page
Loading...
