3.11.3 Dash switch panel
1. Bilge pump
2. Navigation lights
3. Wipers low speed
4. Anchor light
5. Wipers high speed
6. Auxilliary button 1
7. Auxilliary button 2
8. Auxilliary button 3
3.12 TRAILERING
Anytec do not offer a specific trailer for this boat. Your Anytec dealer can recommend
or sell you a suitable trailer. Before placing your Anytec boat onto any trailer, make sure
that the trailer is designed for your boat weight and its shape.
The trailer should have a bow rest, centre keel rollers and keel guards/wobble
rollers which will distribute the weight properly, offering good support for the
keel and hull in both vertical and horizontal direction. Adjust the side supports
so that the maximum boat weight rests on the keel supports and the supports
on sides offer only lateral support.
The mass of your boat in trailering condition is stated in table 3.1. This includes
the weight of the maximum size engine and a fully optioned boat along with full
liquid loads. This does not include luggage/gear weight, any crew or any water
inside the boat. Always remove any unnecessary weight such as loose
accessories and luggage from the boat and drain the bilge water before trailering.
Refer to the engine manual for any specific instructions on trailering, such as the
best engine position and securing method.
Make sure you secure all loose items in the boat. Do not use the canopy, boat
covers or other similar top or cover on the boat during trailering. These can
become detached at high speeds and damage the boat and cause a danger to
traffic.
To Next Page
Loading...