For complete instructions on operation and maintenance, we refer to the separate OEM
owner’s manual that was developed specifically for this equipment. It is provided with the
Anytec document bag.
4.16 HEATER (OPTIONAL)
The Webasto heater is located in starboard pulpit under the helm. Its purpose is to
provide heat to the stern cockpit and to keep the front windows clean of fog and frost. It
runs on diesel fuel. The unit consists of a heater unit, a 10L diesel tank, air outlets below
windows and at feet level on both SB and PS pulpit, exhaust fitting on freeboard and a
control panel on dash panel that operates the system.
Note: Do not use the hatches which install the heater and the heater tank for any
storage. This is very important to ensure safe operation and ventilation of the heater and
the tank. The hatch has a “no storage” sticker; if it is not visible anymore, it should be
replaced.
Operation
Prior to use, make sure that the fuel tank is full. The 10L diesel tank, located in the
Starboard pulpit sofa & storage, can be accessed via sofa hatch. To fill the diesel tank,
first, remove the strap holding the tank in place. Next, remove the cap with the fuel
pickup/return line and pull the tank out of the boat. ALWAYS FILL THE TANK
OUTSIDE OF THE BOAT. When filled, re-install the cap, and secure the tank in the
entertainment centre. Visually check that fuel lines and tank do not leak.
The controller located on the right side dash panel operates the heater.
Fuel vapours can explode. Never smoke or be close to open flames or potential electrical
sparks while handling or filling up the petrol tank. Leaking fuel is a fire and explosion hazard.
Inspect the fuel system annually to make sure that there are no leaks and corrosion in the
system.
Do not obstruct or modify the ventilation system for air, fuel and exhaust gas. Never store
any luggage or other items in the hatch of the heater and heater tank!
Exhaust gas is HOT. Ensure that there is nothing that is susceptible to heat damage (i.e. ropes,
fenders, other boats) within 200mm of the exhaust outlet.
For complete instructions on operation and maintenance, we refer to the separate OEM
owner’s manual that was developed specifically for this equipment. It is provided with the
Anytec document bag.
To Next Page
Loading...