4. SYSTEMS & COMPONENTS__PAGE 52
In neutral, there is a lock button to allow the rpm to increased, for instance for engine
warm-up or tests. Refer engine manual.
Power trim and tilt
At one side of the tip of the throttle handle, there are 2 buttons. One raises the engine,
and the other lowers the engine. This function is a combined trim & tilt functions.
The power tilt (power lift) allows you to raise and lower the engine for trailering and
launching the boat and keeps the engine out of the water while moored at the port. The
power tilt is activated automatically when the engine rises outside the trim (operation)
angles.
The same control is also used for the power trim. At the lower range of the engine
movement angles, the power trim allows you to adjust the engine to create the optimum
boat trim (raise/lower the bow), refer chapter 2.6.
Engine Instrumentation
All modern engines are equipped many sensors, allowing useful information and alarms
to be displayed at instruments placed at the helm. Examples are engine temperature,
rpm, trim angles, fuel filter problems, oil levels and general alarms.
Depending on the engine brand, model and options, the information can either be
displayed on a separate engine control display mounted to the helm, or be displayed on
the Simrad NSS12 Evo3 Multifunction display. In the latter case, the NSS display can hold
all vital data about boat, engine and navigation matters. The display area can be arranged
in numerous ways to fit your personal preferences.
In some cases, customers choose to have a dedicated engine display and the NSS display
mounted at the helm. In addition, most engines have a summer alarm, giving you a
warning noise in case of serious problems.
Due to many variations and possibilities to install and customise the displays, you need to
study the engine and engine instrumentation manuals. They are to be provided by the
Anytec dealer or other company who installed engine and instruments. Understanding
the instruments ensures that you use the engine in the most optimal, economical and
safe way.
For complete instructions on operation and maintenance, we refer to the separate OEM
owner’s manual that was developed specifically for this equipment. It is provided with the
Anytec document bag.
4.7 ZIPWAKE® TRIM SYSTEM
Zipwake is a factory-installed dynamic trim tab system and the most modern on the
market.
Instead of traditional flaps, it uses interceptor blades that extend just maximum 30 mm,
and that can be adjusted very fast. The interceptor blades are installed at the low-end of
the transom, and the control panel is found on the cockpit, see the figure given below.
To Next Page
Loading...