Petrol vapours can explode. Never smoke while handling or filling up the petrol tank. Leaking
fuel is a fire and explosion hazard. Inspect the fuel system annually to make sure that there
are no leaks and corrosion in the system.
1. Do not obstruct or modify the fuel ventilation system, as that could cause fires or
explosions.
2. Do not store any equipment containing petrol (outboard engines, portable petrol tanks,
etc.) in any cockpit storage areas. These compartments were not designed to store petrol
and do not have adequate ventilation.
Gasoline fuels with ethanol content, like E85, could seriously damage your engine and void
warranty. Always check the engine owner’s manual for fuel recommendations and any
approved additives prior to the first use.
For complete instructions on operation and maintenance, we refer to the separate OEM
owner’s manual that was developed specifically for this equipment. It is provided with the
Anytec document bag.
4.2 STEERING SYSTEM
As standard, this boat comes equipped with a hydraulic steering system consisting of a
steering wheel, a hydraulic helm pump, hydraulic hoses and a hydraulic steering cylinder.
An optional steering wheel with tilt function (to adjust wheel angle) is also installed on
certain boats. However, depending on the engine brand and model, the steering system
may have been upgraded to either:
A hydraulic steering system as above, but with power servo for easier turning.
The servo is then located in the stern electrical compartment.
A system with electronic steering control combined with hydraulic servo and
cylinder. The steering wheel controls the power servo by wires instead of
hydraulic hoses. The power servo is installed at the stern electrical
compartment.
For any support you may need, please contact the manufacturer (in most cases it is your
Anytec dealer). Maintenance may include a check of oil levels at the servo, check for
leaks and lubrication of open parts/joints.
For complete instructions on operation and maintenance, refer to separate OEM owner’s
manual that was developed specifically for this equipment. It is provided by the party who
installed the engine.
To Next Page
Loading...