ANYTEC A27 - Measures after Winter Storage; Spare Parts & Service

6. MAINTENANCE__PAGE 80
 Carryout maintenance operation on other accessories and equipment as
described in this chapter and in the respective OEM manuals.
 If your boat is stored outside or in a humid place during the winter, remove
electronic instruments, the textiles, the canopy, cushions, seats and other
equipment that may corrode or become mouldy in moist conditions, and store it
in a dry place.
 Spray the electrical connectors with a suitable moisture repellent antioxidant.
 *Remove batteries and store them in a warm, dry place. Charge them at least
twice during the winter. Spray the electrical connectors with a suitable moisture
repellent antioxidant.
 Check conditions of anodes (refer chapter 6.2.3). Replace if needed. Clean the
surface between anodes and hull to ensure good metallic contact. Never paint
them!
 *Cover your boat so that snow and water will not gather inside. Always make
sure that there is enough ventilation and avoid direct contact between the
boat and the covering material/canvas as it may damage the boat due to
friction and oxidation.
6.4.2 Measures after winter storage
 Check the engine owner’s manual and carefully follow the instructions.
 *Reinstall freshly charged batteries and check voltage.
 Refuel the boat.
 *Install any electronic instruments, textiles and other equipment that was
removed before winter storage. Test them after installation or at first time in sea
before leaving the shore.
 Reinstall bottom drain plug.
 Check the condition of the hull. Repair damages directly. Refresh antifouling
paint if it has been used before, or consider adding new paint if the boat is
moved to new waters (refer chapter 6.2.2).
 Inspect fuel and ventilation hoses and connectors, check for any signs of wear &
tear and leakage.
 Inspect fire extinguisher as per separate owner’s manual.
 Carryout maintenance operation on other accessories and equipment as
described in this chapter and in the respective OEM manuals.
6.5 SPARE PARTS & SERVICE
To ensure the best possible performance, safety and lifetime of your Anytec boat, it is
important only to use high-quality spare parts that are suitable and approved for your
specific boat application. Failure to do so may jeopardise the safety, lifetime and
performance. Anytec offers the parts through the dealer network.