AnyTone AT-D868UV Programming Guide

AT-D868UV CodePlug Programming Guide
V-1.18
Page 16 of 25 © 2017 Trygve Svärd KD0PNQ
Key Function
Key Lock: Select Manual or Auto key lock function
PF1 Short Key: Select from several functions for the radio key below PTT
PF2 Short Key: Select from several functions for the radio key 2 below PTT
PF3 Short Key: Select from several functions for the orange radio key
P1 Short Key: Select from several functions for the P1 radio key
P2 Short Key: Select from several functions for the P2 radio key
PF1 Long Key: Select from several functions for the radio key below PTT
PF2 Long Key: Select from several functions for the radio key 2 below PTT
PF3 Long Key: Select from several functions for the orange radio key
P1 Long Key: Select from several functions for the P1 radio key
P2 Long Key: Select from several functions for the P2 radio key
Long Key Time: Select how many seconds to hold the key for Long duration
SQUELCH TAIL ELIMINATE (STE)
STE Type CTCSS: Off, Silent or a selected setting
STE When No Signal: Select Off, 55.2 Hz or 259.2 Hz
VOX
VOX Level: Select off or 1 to 3
VOX Delay: Select how many seconds of delay
VOX Detection: Select built-in mic or external mic or both
Other
TOT: Max Total Time of Transmit or Off
Frequency Step: In VFO mode, selects the frequency steps
Language: Select language for the programming software
SQL Level A: Set the squelch level for the “upper” channel – set at 2
SQL Level B: Set the squelch level for the “down” channel – set at 2
Scan Type: Select TO – 5 sec stop, CO – 2 sec stop or SE stops scan
Mic Gain: Allows increasing the mic sensitivity
MON Key Function: Set to define the function of the side key for “Monitor”
Brightness: Sets the display brightness – 5 is the brightest
Auto Backlight Duration: Sets the time the display is on or “off” for always on
GPS: Set On or off
TBST: Tone Pulse Freq. Selection for opening certain repeaters
Time Zone: Set the GMT time zone for the radio
Standby wait time: Set the standby wait time
Remote Monitor Funct: When On, the radio can be called and start transmitting
without pushing the PTT
Get GPS Positioning Func: When On, the radio can be called to send its GPS position
Select TX Contact Funct: When On, the radio DMR ID can be changed from keyboard
Auto Repeater: When On, changing the TX frequency via keyboard, will also
change RX with correct offset.

AnyTone AT-D868UV Specifications

General

Brand	AnyTone
Model	AT-D868UV
Category	Two-Way Radio
Language	English