AnyTone AT-D868UV Programming Guide

AT-D868UV CodePlug Programming Guide
V-1.18
Page 19 of 25 © 2017 Trygve Svärd KD0PNQ
Analog Alarm
Emergency Alarm: Select from Alarm, Transpond + Background, Transpond + Alarm,
or Both
ENI Type Selected: Select from None, DTMF or 5Tone
Emergency ID: When ENI Type choose DTMF or 5Tone, you should edit the DTMF
or 5Tone firstly, then choose the required number in this column
Alarm Times: Select after what time the alarm should be initiated
Duration of TX: Select the duration of the Alarm transmission
Duration of RX: Select the duration of listening mode after an alarm reset
Emergency ENI: Select which channel the Alarm should be sent out on
Emergency Ch.: Select which channel to use
Emergency Cycle: Select Continuous or a time
NOTE: A channel is the No. on the Channel Menu line for the selected frequency.
Work Alone
Response Time: Select the time for the radio to respond to an Alarm trigger
Warning Time: Select the duration if a warning transmission
Response: Select Key or Voice for a response to reset
Digital Alarm
Emergency Alarm: Select one of 4 options for how to initiate an Alarm
Alarm Time: Select after what time to initiate the Alarm
Duration of TX: Select the duration of the Alarm transmission
Duration of RX: Select the duration of listening mode after an alarm reset

AnyTone AT-D868UV Specifications

General

Brand	AnyTone
Model	AT-D868UV
Category	Two-Way Radio
Language	English