AnyTone AT-D868UV Programming Guide

AT-D868UV CodePlug Programming Guide
V-1.18
Page 24 of 25 © 2017 Trygve Svärd KD0PNQ
After a re-start the radio will display the setting of the date and the time. Use the up-
down key to set the current year. Move to the month by pushing the P1 key. Set the
month, and use the P1 key to move forward each step. Once done, click the Menu key
to save the date and time.
You may now see the Chinese language. If it starts with Chinese, click Menu, scroll
down to the grey cogwheel globe and click Menu, click Menu 1 more time (Radio Set)
and scroll down to item #8 (Language) and click Menu and select English.
The codeplug has also been replaced as part of the system re-set, so you need to re-
load your codeplug into the radio to make it work the way it should. Please remember to
update your DMR ID number and the start-up display if you use a codeplug from the
Internet.
AT-D868UV RADIO ICON SOFTWARE UPDATE
NOTE: This is a very rare update and may never require to be done!
Download 3 firmware files from AnyTone:
With the same QX Code Update software as above, “Open
Update File” and open the D868_1G_new_usb.spi file
Connect the radio (powered off) to the programming cable and then to the computer
USB port.
Power on the radio while holding the PTT and the button with the two lines below the
PTT. The radio should display UPDATE MODE on the front display.
Click “Write” and the firmware should load into the radio showing the progress as below.
Turn off the radio, and power it back on to restart
it.

AnyTone AT-D868UV Specifications

General

Brand	AnyTone
Model	AT-D868UV
Category	Two-Way Radio
Language	English