APT 8520 - Page 47

© Ikonix USA
43
4.5.3 Delete
1. To Delete a test le select the Mode and go to
the File menu to view the list of test les. Press
the number 4 key on the keypad to view the next
page:
2. Use the rotary knob to select the le to be
deleted. The Delete selection will appear on the
menu bar, press the number 2 key on the keypad
to delete the highlighted le:
3. The following message will appear on the
screen to conrm that you would like to proceed
with deleting the selected le. Press the number
1 key on the keypad to select Yes, or press the
number 2 key on the keypad to select No. If Yes is
selected the le will be permanently deleted and
the screen will display any remaining test les.
4.5.4 Load
1. To load a le select the Mode in which the
le was created and access the File menu. The
selection to Load will appear on the menu bar:
2. Press the number 3 key on the keypad to
select Load and the screen will change to the test
screen. The test le name that was loaded will
appear on the screen:
4. The power source will start outputting if you
press the OUTPUT/RESET key on the front panel.
Make sure all of the output connections are
secure and all other safety precautions are taken.