Aqua SALT+ - Pool Settings Menu

AQUA SALT
+
MAINTENANCE AND INSTRUCTION MANUAL
Salt chlorine genera ENGLISH
ADSP7000753 rev. 5.0 09/07/2019 20/51
Sets the amount of water contained in the pool, with progressive increases of 0.5 cu. m or 100
gal.
Selects the work mode of the chlorine generator choosing among “external timer”, “proportional”
Sets a programmable time from 1 to 12 hours after which chlorine generator will decrease from
50% to 10% of the initial value gradually within 24 hours. (see Special modes paragraph 2.3).
Default value: 3 hours.
Last
modification
Pool
settings
System
settings*
Chlorine/Redox
calibration*
pH
Calibration*
Programming *
Alarms
Comunication
Pool capacity
Generator
operation
Cover filter
It shows the date of the last
modification to at least one
of the system parameters
Switches to the Pool
Settings submenu
Switches to the System
Settings submenu
Switches to the submenu to
calibrate chlorine or Redox
probe
Switches to the submenu to
calibrate the pH probe
Switches to the
Programming Menu
Switches to the Alarms
Menu to enable or disable
the alarms
Switches to the
Communication Menu
4.5.1
Pool
settings
menu
This menu sets some parameters of the pool and other operation characteristics:
• Press F to scroll the menu sections
• Press and hold Enter for more than 1 second to go back to the Pool Settings section of the Installer
Menu.
Pool capacity
Generator
operation
Cover filter
Last
modification
date
Pool settings
System settings
Chlorine/Redox
calibration
pH Calibration
Programming
Alarms
Communication