Fitting instructions# 3789528
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
45. Position template onto bumper as shown and
using a marker pen, mark contour onto bumper
until it meets other line on bumper.
46. Carefully remove the template and repeat
steps 39-45 for LHS.
47. Using a jig saw or similar, carefully cut along
marked lines.
48. De-bur the cut edges with a file or sandpaper.
Note: It is advised that you take steps to prevent
damage to the bumper when cutting such as
placing extra masking tape on the kept portion
of the bumper.
49. Position cut bumper onto bumper retention
block set aside and mark a line onto block as
shown using a white marker pen. (RH side
shown)
50. Remove cut bumper and carefully cut along
inside edge of marked line using a multitool.
51. Repeat for LHS.
52. Use a file or sandpaper to de-bur all cut
edges.
53. Set aside for re-fitment later on.
Warning: Cutting operations
can result in flying debris,
safety glasses should be
worn.
Warning: Cutting operations
can result in flying debris,
safety glasses should be
worn.
To Next Page
Loading...
